Installing a SpeedyLink
1. Lift the seat bottom to expose the battery compartment. You will see the RUN/TOW switch between the batteries. If your cart does not have a RUN/TOW switch, it is not a Precedent IQ and the SpeedyLink will Not work with your cart. Put the RUN/TOW switch to the TOW position and lower the seat bottom back into its normal position.
2. Locate the plastic access panel in the very rear of the cart in the cargo/golf bag area. Using a #2 phillips screwdriver, remove the two screws located on the upper half of the panel. Retain the screws for re-installation later. Gently pull the panel toward you and up at the same time to remove it. There are two plastic inserts where the screws were, be sure to keep them intact for re-installation of the panel.
3. Locate the electric motor that is now exposed. You will note a number of large gauge wires going to the motor. Be sure not to disturb them. Toward the back and right of the motor, locate three smaller wires going to a grey connector. The wires will be Black, Red and Green. This connector is the same type as the SpeedyLink, and is where the connections will be performed.
Note that the Black, Red and Green wires from the motor to the connector are relatively short. Extreme care should be taken. Do NOT pull on the wires themselves. Serious damage could result.
4. De-mate (separate) the three pin connector halves by pressing down firmly on the locking tab, while pulling the connector halves apart. A slight rocking motion between the two halves may be required to separate them. (Don’t pull on the wires, just the connector bodies).
5. Connect the SpeedyLink
a. The Speedylink connector with the Yellow wire in it will mate to
the motor connector you just disconnected from the harness. Make sure
to align the connectors correctly (green will align with orange) and
firmly push them together until they “click” together.
b. The Speedylink connector with the Blue wire in it will mate to
the harness that goes to the computer/controller. Make sure to align
the connectors correctly (green will align with blue) and firmly push
them together until they “click” together.
c. Secure the Speedylink and wires utilizing “zip ties”
to keep them from hanging down or chaffing.
6. Replace the rear access panel and secure with screws removed in
step 2.
7. Return the RUN/TOW switch to the RUN position – You are DONE!!
Be sure to use Caution the first time you run the cart. Get the feel of the cart, as it will perform differently. Of special note is that the cart may “coast out” more when you back off the throttle than you are used to. This is normal. The most dramatic results from your new SpeedyLink will be experienced with good batteries on a full charge. Enjoy and be Safe!